Ok i’m very new to Zbrush but i’ve been using mudbox for a while but zbrush looks like where its at. So I started looking at some basic tutorials and went for it, anyway basically I trying to remesh a Mannequin that i’ve posed which from the videos looks simple enough but when I hit remesh on mine it turns into a load of blobs. link below shows what i’m talking about.
http://www.flickr.com/photos/94620377@N06/8613551323/in/photostream
any help with this would be great
im not going to go into full detail with polish tweaks and polygroup it when i explain.
but once in preview mode >tool>Make polymesh 3D
then under tool geometry>dynamesh it around 600 resolution
then QRemesh it around 20 for target poly count
http://i.imgur.com/S8mblkd.jpg
[img]http://i.imgur.com/S8mblkd.jpg[/img]the image on the left side is the original , the image on the right side is when its finished.
http://i.imgur.com/TjeKXvQ.jpg
This might be a little late, but if you press the A key and then remesh all, it should work.
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.