Subdividing Splines

#1

Is their any way to add a point in the middle of a spline, like the knife tool does with a standard poly?

#2

Select your spline and use the add points tool… Its under the muliply tab.

#3 
     The easiest spline dividing tools are EasySpline's Spline Point and Spline Density, both interactive tools. You can see their videos on [http://www.easyspline.com](http://www.easyspline.com)
 EasySpline is also available in TrueArt's Modeling Pack [http://modelingpack.trueart.eu](http://modelingpack.trueart.eu)

Windows 32 bit, Windows 64 bit, Macintosh CFM and Macintosh UB are supported.

#4

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.