Struggling with a simple model


I am strugling with a model. I tried a bend deformer and a twist deformer but nothing works.
Any body have a clue to model a form as picture attached?


Have you tried a sweep ?

Though a bit more tedious, you could use a loft


The Bend Deformer was along the right lines, you just need to rotate it 45°

You can control the radius of the bend with the Y-Axis length.
I would recommend turning on Keep Y-Axis Length too.



The spline wrap works too . . . Also RenatoT’s Pathdeformer the free plugin a couple of posts below


Thanks a lot Brasco/
This was exactly what I needed.
I forgot to do the 45 degrees rotation.
And @laurent I will try the Pathdeformer too. Thanks for that one.