Hi There
i have a problem whilst trying out reactor cloth, i have draopped a cloth onto the ball and then 100 frames in started to rotate the ball, the cloth goes form hugging the ball (ball1) to gradually letting go of the ball (ball2) and finally just hanging on by a thread (ball3).
has any one got any ideas on this one?
please
thaks
Rob
Hello, I ran a simulation and I’m not having any problems. This is how I did it:
You already created a sphere and a plane object and positioned over the sphere.
Then you create a cloth collection.
Then you click on the plane/cloth and got to the modifier tab and select reactor cloth.
Then you click on the cloth collection icon and add the plane/cloth
Then select the sphere and open the property editor on the reactor side bar.
A window pops up and there should be 3 tabs: Physical properties - Simulation Geometry - and display. In simulation Geometry, mesh convex hull should be checked. In physical properties, unyielding should be checked. Everything else stays the same. Close the dialoge out and run your simulation. I hope this helps you.
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.