Hi,
I’m trying to obtain a bit of follow through of the hair using nHair, preferably only at the tip.
As you might know, by default, the dynamic hair just goes out flat.
So I had both the start attract curve, stiffness scale and attraction scale set at 1 (both at Tip and Bottom)
But the hair still wobbles a lot (though now it is following the initial state).
I managed to adjust all the conceivable settings that may affect this behavior (increasing resistance figures up to 100).
But the hair still wobbles a lot. I only need it to wobble at the tip just to show that the hair is moving.
Is there a way around this?
You can see an illustration here: https://www.dropbox.com/s/2d0halyhbmdyqd2/MYA030_modest_hair_simulation.avi?dl=0
P.S. I already tried messing with the scale (decreasing from default) and substeps (increasing from default) but I still get worse result.