Iron Man Boot Frame - Help!

#1

I’m very new to 3D modeling and wanted to try and model the Mark III mech boot frame from the first film shown here:

I’m using Modo and I basically wanted to ask if I’m on the right track? It’s surprisingly difficult learning a program like this without someone looking over your shoulder to correct your mistakes or offer advice.
Once this side is done I was going to mirror it then modify the right side since it isn’t symmetrical. No hard edges yet.

Left:

Front:

Perspective:

Wireframe:

Does this look right so far?

Thanks :slight_smile:

#2

I think I would have start with the basic shape of the boot and then add details like the metal edges, because it is easier to get a correct shape then. After that I would have add details.

For now, your model seem far too flat to fit on a leg. Except of that, to me it looks like you use your vertexes wisely.

#3

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.