Insert Mesh Problem

#1

Hey everyone.
I am using the insert mesh brush, And I am attempting to carve out pieces of a mesh. However the method is not working like I expected it to. The problem goes as follows

I can insert meshes fine.
Just mask out the area
Make the poly group
Insert mesh,
ctrl drag twice and voila

but when it comes to carving out a piece of the mesh with the insert mesh brush
(alt+drag) It looks like all the vertices get heavily distorted. (I’ll post an image so it’ll make sense)
Any clue as to why that’s happening?

http://imgur.com/a/c7sX4

#2

it bridges from the end caps,
remove the ends from a cylinder and make a new insert brush.
http://i.imgur.com/YNQEN.png

OR try the insertHClinder brush
http://i.imgur.com/thACG.png

#3

close hole if needed tool >geometry >close hole
http://i.imgur.com/3r9kr.jpg

QRemesh it if you want when done
http://i.imgur.com/MOLGK.jpg

#4

YOur name could not be in truer. Thank you very much for the help.

#5

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.