Help with mesh topology

#1

I’m at a sticking point with my mesh and was wondering if someone could help. I can’t seem to get the topology just right on my female bash mesh.

Here’s my current mesh with a draw over of how I want the edge flow to look.

https://dl.dropboxusercontent.com/u/78257325/modelToplogyFix.jpg

long Red line indicates how the edge flow should go. Other red line is possibly moving the pole upward.

Any help will be appreciated :thumbsup:

Thanks!

#2

Hey Derek! Looking good so far. I think your suggestion is correct, I’d make sure you have at least two edges continuing into the shoulder before the architecture for the arm starts:

Also, I’d begin thinking about spacing, trying to get your quads as even and close to squares as possible; you could probably stand to add an edge loop around either side of the midline (indicated by the stars, running vertically); be sure to slide the rest of the edges out accordingly to give room for the chest between the breasts, neckline, and naval.