CurveBridge - How to rotate obj mid command?

#1

Hi all,
New to Zbrush. I saw a video where a guys was showing how he used CurveBridge to make a dress. He started the curve bridge on the front of the figure and then rotated the figure 180 degrees around and then finished the first curve. he then drew the second curve below on another obj and they bridged. I can’t for the life of me figure out how he started the first curve - rotated the figure - then completed the first curve without jumping to the second part of the command.

Does this make sense what I’m saying?

I’m sure it’s simple. Thanks.

#2

so i figured it out by accident. after you rotate if you get hover over next to the end point it will reach out to connect with a red line so you can continue the curve line.

Good Luck!