zTool appending to wrong location/scale

#1

When the zTool is loaded it is at the correct position and scale. However when I append it to any other subtool it loads at the wrong location/scale. Wtf?

#2

Is the too imported from another software? How is it oriented in relation to ZB’s floor? Have you tried to use Unify?

#3

Is the tool imported from another software? How is it oriented in relation to ZB’s floor? Have you tried to use Unify?

#4

Hi, thanks for the reply. The zTool was created in zbrush. I’m using it across zBrush projects, but even in the original in which it was created it appends in the wrong position/wrong scale. The ztool itself is the result of a morph point differential extrusion procedure. I’m not familiar w/ Unify but I’ll check into it.