Performed a simple boolean to create a plug port like always. After the boolean finished, tried to fillet the resulting edge. Returned an “Invalid Input. Nothing done.” error above the command line.
I exploded the geometry, rejoined, and it worked fine. There a step I’m missing?
hi,
I think booleans are a bit tricky so its not easy to tell what went wrong without a pic. Though i would assume somehow you got unjoined edges or naked edges where you wanted the fillet by the boolean. you then may have closed them by exploding > join.
I think that may have been the case. When I was joining them back together there was a straggler (3rd curve where 2 should have been).
If you run into this problem again, try “Analyze > Edge Tools > Show Edges”. Occasionally when I have problems where things aren’t working right, I use that command to find the naked edges and work out the problems from there.
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.