Edgeflow issue.

#1

Hey there,
I am not that good in modeling. So I have a question regarding the following pictures.
In the first picture you can see a very basic model. In the next one Ive added several lines to define the edges. The red lines are causing the issue in the lower part of the model. It isnt round any more, now it has a little bump (picture #3). Is there any trick to avoid this? I tried to spread the lowest vertices of the red lines. But I dont like this edgeflow. So is there any trick?
Thank you in advance.

Regards
Rob

#2

just target wield them

#3

Simply collapse or target weld the verts indicated in e2ectr0nic’s example, then eliminate the vertical interior edge left in that area to maintain quadrilateral topology, if desired.