|05 May 2002||#1|
Join Date: Jan 2002
What's the proportion of the eyeball to the head?
I'm in the middle of my first serious head model and having never seen a whole eyeball, it's hard to tell how big to make it.
you know, is the head 5 eyeballs tall or something like that?
Ten out of ten for style,
Minus several million for good thinking.
|05 May 2002||#4|
Boss at Naviťportfolio
FX Artist & Software Dev
Join Date: May 2002
no, not about 5 Eyeballs... exactly 5 Eyeballs!!! The human body is always exact, but not symmetric! not horizontal line but vertical line (from lower subnasal chin to the upper forehead).
Last edited by Katachi : 05 May 2002 at 10:16 PM.
|05 May 2002||#5|
Join Date: Apr 2002
according to this tutorial the eyeball is (always) roughly 24mm - check it out - it's really nice - http://www.computerarts.co.uk/tutor...al.asp?id=23082
|05 May 2002||#6|
Lord of the posts
Join Date: Feb 2002
I know that the face is 5 "eyes" across it's width, but I am curious about the "eyeball." If you plucked it from the head and looked at the relationship in size.
Hmmm, here is what that site said:
The diameter of a human eye is roughly 24mm, while the diameter of the iris is normally half that of the eye - here it's 12mm. Of course, the size can vary by +/- 1-2mm.
Thanks for the link, I think that is helpful.
|07 July 2002||#7|
the little scientist
Join Date: Jun 2002
just found out that the head is 5 eyeballs in width and 7 in height, the forehead is about 3 eyeballs, and the nose is about 2.
one eyeball between the eyes and one on each side. the nose is an eyeball in width and the mouth is 2. and so on... hope this helps abit anyway. and these are the male proportions.
|08 August 2004||#8|
Join Date: Aug 2002
the link above does not work any more :/ .
So what's finally the size of the eyeball ( I mean the sphere, not the visible part of the eyes)?
Is it 24mm - 5 eyeballs across the width?
Edit: if it's 24mm, whats the normal width of a woman face?
Thanks in advance,
Last edited by reiv : 08 August 2004 at 09:55 AM.
|Thread Closed share thread|