"Simple Extrude" - need help

Become a member of the CGSociety

Connect, Share, and Learn with our Large Growing CG Art Community. It's Free!

Thread Tools Display Modes
  11 November 2005
"Simple Extrude" - need help

How can i write this in C.O.F.E.E. language?

1) Save current command ID in variable

2) Call Command "Extrude"
3) Set "offset" to 0
4) Execute

5) Call Command with saved ID number


Last edited by Neldor : 11 November 2005 at 08:57 PM.
  11 November 2005
Check out SendModelingCommand() in the SDK documentation, this is what you need. The issue is that you have to tell it what to use (points/polys/edges) which means that you have to determine beforehand what to use. You could attempt to use a callcommand followed by normally setting up the values then sending one of the Message description commands, though i'm not sure how successful that would be as i dont' know if coffee can send the correct data with the message.
The Third Party | Homepage | My Reel
"You need to know what you're doing before you start, and to start because you need what you're doing."
  11 November 2005
Thread automatically closed

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.
CGTalk Policy/Legalities
Note that as CGTalk Members, you agree to the terms and conditions of using this website.
Thread Closed share thread

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Society of Digital Artists

Powered by vBulletin
Copyright 2000 - 2006,
Jelsoft Enterprises Ltd.
Minimize Ads
Forum Jump

All times are GMT. The time now is 03:07 AM.

Powered by vBulletin
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.