|03 March 2013||#1|
Ik spline handle , spine stretching issues
so I have a joint chain for a spine set up with an ik handle and three controls to drag the clusters controling the spline.
ive got a simple strech system set up,
where ive created a curve info node using the arclen -ch1; command.
in this case arclen is 141.789.
I create a Multiply divide node,choose divide and
connect the arclen to input1X in a multiply divide node.
I put in ive 141.789 into input2x and connect outputX
from the multiplydivide node to each joint in the chain.
here is the problem
as seen in picture 2 and three the end joint where the joint chain ends
goes crazy and extends beyond its position if i pull the curve too much
is there a way to solve this?
if anyones interested in helping me, or know a better/smarter/more efficient way to do it please let me know! And want to see the file itself ill gladly email it to you
|03 March 2013||#2|
I think it's the downside of using spline IK. The spline ik tends to overstretch itself. I believe it has something to do with the calculation of the arclenght and the round off of the numbers. I could be wrong though . You should google ribbon spine. It's a really good alternative to using spline IK for the spine and it's used a lot in rigging characters.
It's probably not the answer you were looking for but I hope it helps you anyway.
good luck with the project
|03 March 2013||#3|
Thread automatically closed
Note that as CGTalk Members, you agree to the terms and conditions of using this website.
|Thread Closed share thread|