|12 December 2012||#1|
Join Date: May 2012
Insert Mesh Problem
I am using the insert mesh brush, And I am attempting to carve out pieces of a mesh. However the method is not working like I expected it to. The problem goes as follows
I can insert meshes fine.
Just mask out the area
Make the poly group
ctrl drag twice and voila
but when it comes to carving out a piece of the mesh with the insert mesh brush
(alt+drag) It looks like all the vertices get heavily distorted. (I'll post an image so it'll make sense)
Any clue as to why that's happening?
Last edited by Pmiller : 12 December 2012 at 05:58 PM.
|12 December 2012||#2|
Join Date: Dec 2011
it bridges from the end caps,
remove the ends from a cylinder and make a new insert brush.
OR try the insertHClinder brush
Last edited by informerman : 12 December 2012 at 04:16 AM.
|12 December 2012||#5|
Join Date: Sep 2003
Thread automatically closed
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.
Note that as CGTalk Members, you agree to the terms and conditions of using this website.
|Thread Closed share thread|