View Full Version : looking at polys 90 degrees?


theboykidney
10 October 2003, 04:39 PM
Hi,
Is it possible to have a poly selected and then frame it in a viewport so that you are looking at it at 90 degrees? it would be pretty handy at times if it was possible...
cheers

Cinematography
10 October 2003, 05:24 AM
I think hotkey 'F' [for frame] is what you're looking for. I'm not completely sure though.

tachy0n
10 October 2003, 08:32 AM
Check out reference planes in the manual...

theboykidney
10 October 2003, 09:35 AM
cheers cinematography, but if you frame it "F", it stays at the same angle you were looking at it....as for reference planes, i'll investigate.
cheers guys

Heber
10 October 2003, 05:16 AM
hit those little buttons at the top of the viewport that say x,y,z to lock the cam to a certain axis ,

CGTalk Moderation
01 January 2006, 01:00 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.


1