View Full Version : Mesh no render after Approximation Editor

01 January 2011, 08:27 PM
I have a poly mesh that does not render after I assign it in the approximation editor. There are other meshes in the same one that work just fine. Any ideas as to why this may be happening? I read through a few old posts, one which mentioned doing a cleanup, which I have done and still the same result.


01 January 2011, 12:05 PM
This would happen if the geometry was non-manifold.


CGTalk Moderation
01 January 2011, 12:05 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.