View Full Version : Looking for tips

10 October 2010, 01:30 AM
I'm new to 3D modeling and am wondering if there are any pointers for best way to model this column decoration? It's round but the top is straight. I did each piece but then connecting is a pain. Wondering if better way...
I only have the front view.

Link doesn't seem to insert so here it is:

10 October 2010, 03:48 PM
Profile - extrude. I'd make it by moving vertexes, by use blueprint (side view).

CGTalk Moderation
10 October 2010, 03:48 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.