View Full Version : Pinching at nurbs poles

03 March 2010, 05:17 AM
I needed a way to keep the pole areas of a nurbs surface from pinching and pulling apart. I came up with this ( - which uses a second soft body to drive the ends. It works ok, but it is twice as much work to set up. I am new to dynamics, so I would like to know what the usual way of solving this problem is.


CGTalk Moderation
03 March 2010, 05:17 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.