View Full Version : how to make flat corners with specific alignment?


cgbeige
12 December 2009, 07:04 PM
I've been trying to figure this out for a long time but I can seem to get it. I have this sculpture that I want to look like it's meeting the floor so I want to get a sharp edge near the bottom. The problem is that if I use the pinch tool and flatten, it's still going to be all over the place and not be perfectly flat. How do people go about this with Mudbox?

goodvibrato
01 January 2010, 01:53 AM
Did you find an answer to this yet? You might try using the flatten tool, but with center normal, instead of average normal under the advanced settings. That should at least get it evenly flat.

CGTalk Moderation
01 January 2010, 01:53 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.


1