View Full Version : Surface Connection Problem...

09 September 2008, 04:31 PM
Hey all,

couldnt get a response to this in the WIP forum, ...the cap on my nurbs cyl. isnt conforming to the actual cylinder...heres the screenshot...maybe someone can help me out? Tried a few things like higher res dice. (

02 February 2009, 05:20 AM
Did you try matching the tesselation on the cap with the base of the table?

02 February 2009, 02:24 PM
it was so long ago and so simple i dont remember what I i think i just connected the two pieces. im such a noob.

thanks tho

02 February 2009, 02:59 PM
can you post a wireframe of the table only? and a closer look on it as well would help. no chairs :)

02 February 2009, 06:47 PM
as i said i fixed it but i dont remember exactly what i did...i think i just attatched the surfaces.

But ill post em anyway.
By smokinls ( at 2009-02-05
By smokinls ( at 2009-02-05

CGTalk Moderation
02 February 2009, 06:47 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.