View Full Version : blendshape has slight jiggle after recombo

08 August 2008, 10:48 PM
I am making blendshapes for a character and I thought i would try the extract head mesh and recombine head to mesh method I found in the archives, as opposed to using the whole mesh-sending it to zbrush to make faces
then back to maya.

Doing it with the head only-I bring it back, recombine, but I get a slight jiggle in the mesh where the head was reattached.
I checked the vertices-they were recombined ok...

I did it the old way and had no jiggle.

Anyone know what might cause the jiggle-I saw the post about blendshape oddities --but this is happening prior to rigging.

Also-what do I save by not using the whole mesh for the blendshape? I cant notice any difference in speed between the blendshape methods.

08 August 2008, 04:07 PM

CGTalk Moderation
08 August 2008, 04:07 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.