XM Magdalena 3D print, GGeorgy (3D)
LC #42 Pipers Alley

View Full Version : Orient Constraint

01-01-2008, 07:19 PM
Hi ,

I am working on a character setup .
As i apply orient constraint on two joints or joint and handle , it dislocates the joints.( moves the joints from its original position )

kindly suggest .

01-02-2008, 07:37 AM

can post a pic of "moves the joints from its original position" thingy ?

b'se if u r constraining and things move off !! =>> then either its ur channels being locked or else your "keep offset" is turned off on ur constraint optons...

but if u r trying to use an orient constratint and it flies off to a new POSITION !! :eek:

CGTalk Moderation
01-02-2008, 07:37 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.