View Full Version : How to Programatically Align a Joints X Axis to the Joint Itself?

09 September 2007, 10:28 PM
I've seen it done in some auto rigging scripts, but how would you go about aligning an axis (XYZ, whatever) to run along a joints length?

*edit* heh, found it. Nifty little option in the joints command, oj='' :)

CGTalk Moderation
09 September 2007, 10:28 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.