XM Magdalena 3D print, GGeorgy (3D)
LC #42 Pipers Alley

View Full Version : Knee Constraint in Stretchy Rig Help Request

S. J. Tubbrit
06-03-2007, 12:49 AM

I'm utilising the StretchyIK Setup from Highend


Would anybody have any suggestions as to how I may go about adding a knee constraint into the rig, I've tried setting up a pole vector constraint beforehand, but the script just knocks it out of the equation, any help appreciated.


06-03-2007, 02:18 PM
I use this script, I always just setup the PV afterwards.

S. J. Tubbrit
06-03-2007, 02:50 PM

As usual, faffing about for ages, then finding out the most obvious....



CGTalk Moderation
06-03-2007, 02:50 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.