XM Magdalena 3D print, GGeorgy (3D)
LC #42 Pipers Alley

View Full Version : Omg Help

03-11-2007, 02:03 AM
I just got mudbox and i imported an .obj from XSI , i'm trying to use bulge and pinch and what not but look what happens


03-11-2007, 03:43 AM
Are you using a tablet? If so try pressing lighter or playing with the Pen Pressure settings on the right (when any tool is selected). I also looks like your poly count may be too low, try subdividing. Increasing you're brush size could help too.

03-11-2007, 10:33 AM
The brush strength is too high.

03-11-2007, 11:47 AM

Brush strength too high.

Although I havent seen PINCH do that!


03-12-2007, 07:42 PM
Thx for the help guys..will try tonight, see if what you guys said works.

03-13-2007, 09:48 PM
well i took all of your advice ...but its still happening . however...when i created a sphere and sub-d'd it..everything was working fine..so i'm guessing something to do with xsi exporting the model incorrectly into a .obj or something like that...

03-13-2007, 09:53 PM
i'm guessing something to do with xsi exporting the model incorrectly into a .obj or something like that...

That's possible. I know Lightwave's OBJ files come out very tiny in Mudbox, so you have to scale it up like 14000% before exporting. I'm not sure if Mudbox uses any sort of real-world scale, like a head being roughly 1' tall.

03-15-2007, 12:22 AM
damn it....now its doing the same thing with just a regular spherre sub'd' 3 levels created in mudbox...also stamp isn't working...i think the whole install was corrupt...:shrug:

03-15-2007, 02:09 AM
the same thing happened to me, you mesh is too small relatively to the grid (ie: scale your mesh a bit)

03-15-2007, 07:58 AM
Its a scale issue, scale it up at least 10X.

03-19-2007, 03:01 AM
try deleting your settings folder, then trying again

CGTalk Moderation
03-19-2007, 03:01 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.