XM Magdalena 3D print, GGeorgy (3D)
LC #42 Pipers Alley

View Full Version : Parameter wiring bipeds

05-02-2006, 03:21 AM
I tried to use a rig for finger controls for a biped hand, but found that the list rotation controllers don't work i.e, if I move the hand, then apply a finger movement using the rig, the hand flips back to where it was. What gives?

05-02-2006, 03:29 AM
Is your biped in figure mode?

If you're trying to animate, you need first to turn off figure mode, then use autokey or the key interface in the biped rollout, not the "set key" button next to autokey.

There could be other reasons, I'm just guessing.

05-02-2006, 08:17 AM
No, I'm not in figure mode but i've solved the problem...thanks anyway

05-02-2006, 06:09 PM
What was it?

05-04-2006, 02:42 AM
put 'autokey' on

CGTalk Moderation
05-04-2006, 02:42 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.