View Full Version : Path + Pattern question

12 December 2005, 01:59 PM
Hi there!

I'm stuck with a problem in pshop. I made a path and a pattern. I want the pattern to transform as the path. Not just a straight line. I can't figure this out... I tried the help but i did not came any further the the warp tool and the vanishing points.

But i don't want to scale the pattern, it just has to fit on the pathline.

I guess you could just paint the pattern by hand, but then the pattern isn't constant and 100% accurate anymore.

I hope you guys can help me out!

Thx a lot!

12 December 2005, 03:35 PM
just use a basic brush, set the size, hardness, and the spacing to what you are looking for. then in the paths pallete click on "stroke path" icon at the bottom. No need to make a pattern for this job.

12 December 2005, 07:36 PM
Thx man! this will do the trick

CGTalk Moderation
12 December 2005, 07:36 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.