View Full Version : Smoothing Issue

07 July 2005, 10:28 PM
I am having an issue when I smooth the hood of the 350z that I am modeling. All of my polys have 4 sides but when I smooth. It is a linear smooth based in Maya with a subdivision of 2. I get a weird "rounding" out effect. Pictures are below. Any ideas or help would be greatly appreciated. (wire image) (smoothed image)


07 July 2005, 12:01 AM
Check out the image, you've actually got a few polys with more than 4 sides...:D

07 July 2005, 06:44 AM
Yeah, just because it's a straight line doesnt make it one edge. From one vert to another counts as an edge or "side"

Putting that aside it seems like you have a few spots where 5 poly's would all meet at one vert which could also cause some distortion. It may be better to just have the extra edge loops run around the whole model

CGTalk Moderation
07 July 2005, 06:44 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.