View Full Version : Master and Servant 3D Entry: Victor Leandro dos Santos

03 March 2005, 02:13 AM
Victor Leandro dos Santos has entered the Master and Servant 3D.

03 March 2005, 02:21 AM

the boy created a robot for being able to control and to use the robot to do robberies in banks
but maybe I only leave the boy on top of the robot holding the control.


03 March 2005, 03:21 AM
iae carinha!

Its cool see you on it, Your sketch looks pretty cool, maybe I just didnt like the person topology, the robot is pretty nice.

Good luck

03 March 2005, 03:54 AM
Thank you, Amon-Ra

the boy topology was made of any way

03 March 2005, 04:24 AM
good luck Victor L. Santos (V-Max), we from Brazil are with you!

03 March 2005, 05:21 PM
Heya, man! Nice to see you here! Best lucky! Manda v carinha!

03 March 2005, 08:09 PM
nicee nicee..
good luck !!
queru ve mais ai einh vein !! t+

03 March 2005, 12:06 AM
Hello boys.
Thank you

Today didin't give for me to begin to model to model, but tomorrow I will begin later I show, ok?

03 March 2005, 04:41 PM
Nice sketch man!! Can´t wait to see the modeling!!
keep it up and good luck my friend! :thumbsup:

03 March 2005, 04:46 PM
nice skech
good luck dude

03 March 2005, 08:53 PM
good sketch,

don't give up now, keep going:thumbsup:

Lígia MB :)
04 April 2005, 01:46 AM
Hi Victor! I´m very happy to see you for here! Wow, who would say, hein? Congratulations for you evolved so fast in 3d...! Excellent idea, we are waiting its ups!

04 April 2005, 02:58 AM
Thank you

I won't participate more, it is that I am not prepared for a challenge as big as that, it is that also I am encouraged with some test that I am doing to get better

na próxima talvez eu participe, é q estou empolgado com uns teste que estou fazendo. principalmente d textura d pele.

04 April 2005, 05:01 PM
Hope that you can show more... Good luck!

04 April 2005, 12:54 PM
Go ahead !!!

CGTalk Moderation
04 April 2005, 12:54 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.