XM Magdalena 3D print, GGeorgy (3D)
LC #42 Pipers Alley

View Full Version : little problem using Fur in Maya

01-29-2005, 08:37 PM
Hi there,
I hope this is the right forum to post my problem, I'm sorry if it's not :)

Well, the problem is, that i wanted to apply Fur on a Sphere where I extruded some faces. Thr Fur works fine, but only on the sections that belonged to the sphere before, not on the faces that where extruded, You can see what i mena in the picture below.

Any ideas what I can do to prevent this?

Thanks in advance,


01-29-2005, 08:43 PM
This is most likely an issue with not having proper UV's for your fur. Check the docs for details.

01-29-2005, 08:53 PM
well, thanks. sound pretty reasonable. since i'm still a complete noob to maya i don't actually know how to get a proper UV, but i'll seee what i can do.

thanks a lot,

CGTalk Moderation
01-29-2006, 09:00 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.