View Full Version : Looking for modeling Tips and Tricks

10 October 2004, 07:51 PM
Looking to model something like this, if you have any tips, or tricks, please, drop a message!

I was thinking about doing a spline and then rail extrude that way, but then I would have some problems with the box part of the model.

Thanks guys, and Hello to people who remember me!

10 October 2004, 02:06 AM
AndrewE I think there are some tutorials on this site ( Ed Giddings, incredible artist) that might be what your looking for.

10 October 2004, 03:40 PM
Couldn't you just to a rail extrusion like you were going to, then flip the polygons, sub divide the surface as much as you need, and then bevel the polygons? Maybe use radom select to have diffrent surface settings for diffrent groups of Polys? Better yet why not just make highrez UV clipmap that goes down the length of your tube using UV spider?

CGTalk Moderation
01 January 2006, 01:00 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.