View Full Version : poly smooth lvl ??

04 April 2004, 10:09 PM
Hi everyone

i want to keep this question software non-specific as possiible,
here goes :

when making a modeller demo reel, and showing off your poly wiremeshes, what should be the division lvl ? if i keep it at 2 then the mesh is too dense and doesnt show the topology well, but the rendered shaded geometry is at division lvl 2, so should i leave the wiremesh lvl at 2 too, and also is there a good way to render out wireframes,(maya). ??

CGTalk Moderation
01 January 2006, 01:00 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.