XM Magdalena 3D print, GGeorgy (3D)
LC #42 Pipers Alley

View Full Version : Challenge WIP: Dickie

01-28-2002, 01:46 PM
My original mesh got toasted when my hard drive crashed.
So these past couple days I've frantically pieced the little dude back together from scratch. He still has a ways to go but here's a peek:


Feedback is definately welcome. C'mon people!


01-29-2002, 01:41 AM
looking good Defintly start woirking on the clothes, adding detail etc. and the proth part and the hands and the priate themed accessory, and [out of breath] The modeling on the chest is top notch so definately keep that exposed! His shoulder bones(scapula?) are a bit too far towards the spin, but I doubt they will be seen anyway :) Better get working :eek: :eek:

See you,

PS mine's around here too if you want to give a crit :rolleyes:

CGTalk Moderation
01-13-2006, 01:39 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.