XM Magdalena 3D print, GGeorgy (3D)
LC #42 Pipers Alley

View Full Version : Particle problem in Combustion

06-22-2002, 01:16 AM
Ok here's my problem. Whenever I use a particle (which has become quite rarely because of this) Combustion goes mental.
It works fine in Medium and Draft modes, but when I try to use Best or Preview the picture just becomes either white, or black with a white square at the bottom left corner.
This happens both in the preview window and if I render a movie.
Here's what a rendered movie ends up looking like:

Any ideas to what I'm doing wrong?


06-22-2002, 06:00 AM
This depends, is this Combustion v1 or v2

06-22-2002, 06:58 AM

06-23-2002, 09:33 PM
Try changing to software openGL rendering & see if that fixes the problem (I've seen a couple of similar problems like this on C2 & it was the openGL card)

06-24-2002, 01:07 AM
I've tried both with and without Open GL. It's the same in both.

07-07-2002, 08:00 AM
have you got the 2.1 patch from discreet??

Without this patch, C2 particles are useless!!

CGTalk Moderation
01-13-2006, 10:00 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.