XM Magdalena 3D print, GGeorgy (3D)
LC #42 Pipers Alley

View Full Version : Tiger I & Thompson M1a1

11-18-2003, 02:03 AM
OK first post so Hi, Some back ground info on me for those who care. Ive been modeling for about 5 months now (still learning stuff) I planing on skining both the tiger and thompson when I get beter at it. Hope ya like them

TTM[time to make]

Thompson M1A1 Polycount- 2823 TTM-3 hours

Tiger I Polycount 199,928 TTM-2 Days



11-18-2003, 04:20 AM
good show man...nice work...

11-18-2003, 06:35 PM
This is quite nice.

There are a few minor issues with some of the proprtions on the tank, though:

1. The commander's cupola is too narrow

2. The glacis appears to be too thin

3. The tank should ride a little higher. When looking at reference photos for the Tiger I, take a look at the angle and elevation difference between the front road wheel and the toothed drive wheel in front. Beware of using photos of vehicles that have burned, as the heat causes the suspension to 'lay down', giving a lower silhouette, similiar to what you have here.

4. Never mind, error in my research (edit)

All in all though, it's quite good. I particularly like the detail on the engine decking.

11-18-2003, 10:25 PM
whoa nice models. I especially like the tommy gun. My dad had one just like it a while back.

11-19-2003, 03:18 AM
nice work!:thumbsup: i like the tank but there are some things that u have to adjust . "Malaveldt" has mentioned tham alredy i guess.

keep the good work going!:thumbsup:

11-19-2003, 06:51 AM
Yeah I'm in agreement, you have some nice models.


Visit ARTOMIKE.COM (http://www.artomike.com)

CGTalk Moderation
01-16-2006, 05:00 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.