CGTalk - looking at polys 90 degrees?

View Full Version : looking at polys 90 degrees?

theboykidney

10-29-2003, 03:39 PM

Hi,
Is it possible to have a poly selected and then frame it in a viewport so that you are looking at it at 90 degrees? it would be pretty handy at times if it was possible...
cheers

Cinematography

10-30-2003, 04:24 AM

I think hotkey 'F' [for frame] is what you're looking for. I'm not completely sure though.

tachy0n

10-30-2003, 07:32 AM

Check out reference planes in the manual...

theboykidney

10-30-2003, 08:35 AM

cheers cinematography, but if you frame it "F", it stays at the same angle you were looking at it....as for reference planes, i'll investigate.
cheers guys

Heber

10-31-2003, 04:16 AM

hit those little buttons at the top of the viewport that say x,y,z to lock the cam to a certain axis ,

CGTalk Moderation

01-16-2006, 12:00 PM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.