PDA

View Full Version : vehicle: WIP: Mercedes CLK ATM

bastiaan
10-19-2003, 03:11 PM
for a lack of reply's here are a few more images of my really wip car! please comment me on how to make it look a bit photorealistic...

front subdiv (http://home.introweb.nl/~wormgoor/subdiv-front.htm)
back subdiv (http://home.introweb.nl/~wormgoor/subdiv-back.htm)
front wire (http://home.introweb.nl/~wormgoor/non-smooth.htm)

oh yeah.. maya 4.5
bastiaan
10-20-2003, 07:15 AM
..eeeh if it's a crappy car.. please tell me!
Emberghost
10-20-2003, 07:18 AM
..eeeh it's a crappy car....

Hehe just kidding, looks like a good start. Maybe straighten things out a little more?
bastiaan
10-20-2003, 07:20 AM
thanks man for the reply! But what do you mean by straighten things out? It took me "ages" to come this far..
Conanart
10-22-2003, 11:54 PM
Good start just keep smoothing and moving points to "strighten things out". Look at the mesh as you would when you buy a car, so look right along one side from the front so you can see any slight imperfection, then tweak and then look again. It takes a while but is well worth it.

Take a look under the rear light as there is a small dent - the side panels have a small wave running through them (about half way up they go in a little) - the trunk has a ding on the back edge next to the light - where the rear door meets the rear wing and upright there is a dent - the area over the front wheel arch looks like it goes in too far.

G
bastiaan
10-23-2003, 01:15 PM
thanx dude! I'm heading back to my modelingstudio hehe!
CGTalk Moderation
01-16-2006, 09:00 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.