PDA

View Full Version : Pflow - Particle Paint question


4 low
11-19-2010, 03:52 PM
This is going to be a two-part question. If the first part is easily answerable, then please ignore the second part.

First, is it possible to have 3 (or more) seperate particle events emmitting from the same object, when I want all 3 events to emit from seperate groups of specific selected faces?

If I create an event, and have it emit particles from the selected faces of an object, it works exactly like it should. But if I want to add an event, and have it emit from the same object, along a separate selection of faces, my previous selected faces will no longer emit from my first event. So is there a way to have particles emit from seperate material IDs of an object? Or are there any other suggestions to achieve what I want?


My work-around has been looking for a way to achieve a simlar result using particle paint, which brings me to the next question.

Using particle paint to paint on particles to another object gives me exactly what I'm looking for--I can paint on 3 separate particle events onto the same surface geometry. However, when that surface begins to deform, the painted particles "slide" around. Here's some pics to describe what I'm trying to do.

First, I have a cylinder to act as my surface geometry emitter. I want to have the Teapot, Cube, and Pyramid to be emitted from separate areas along this cylinder.

http://i292.photobucket.com/albums/mm21/animator752/Pflow/pflow01.jpg



Using particle paint, I'm able to get all three events painted on how I want them.

http://i292.photobucket.com/albums/mm21/animator752/Pflow/pflow02.jpg


Once the cylinder gets deformed--in this case, with the bend modifier--the particles stay in their emitted location.

http://i292.photobucket.com/albums/mm21/animator752/Pflow/pflow03.jpg

Using the "Lock/Bond" operator in pflow, the emitted particles begin to lock to the surface, but they act like they're "sliding" down the geometry of the cylinder.

http://i292.photobucket.com/albums/mm21/animator752/Pflow/pflow04.jpg


Is there a way to get them to stick exactly onto the surface of the cylinder in the position that they were emitted?


My only work-around for either problem is to have 3 separate cylinder emitters, then hide each one from being renderable. Is that my only option?

JohnnyRandom
11-19-2010, 04:58 PM
Here are three cases:

the first uses Mesh Select + Position Object->Lock to Emitter & Animated Shape

the second uses Mesh Select + Position Object + Lock & Bond->Lock to Surface, Animated Surface

the third uses Particle Paint + Birth Paint + Lock & Bond->Lock to Surface, Animated Surface

4 low
11-19-2010, 07:08 PM
Thanks for the file, that helps quite a bit.


I had tried stacking edit-poly modifiers on top, hoping that would allow for multiple selections, but had not tried mesh select.


Looking at your pflow setup, it appears that the Particle Paint + Birth Paint + Lock & Bond->Lock to Surface, Animated Surface was set up almost exactly the same way as the one I set up, so now I'm going through and comparing to see just exactly what's different, and why yours is working and mine is not...

Thanks again for that, it definitely helps, and is exactly what I'm looking for.

JohnnyRandom
11-25-2010, 05:33 AM
No problem. :)

I seem to remember position object will only read the topmost selection. Any modifiers with selections below it will be ignored

CGTalk Moderation
11-25-2010, 05:34 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.