PDA

View Full Version : How do I....

studiomiguel
05-30-2002, 09:49 PM
I'm doing Michael Thompson's nurbs modeling tutorial modeling a Subaru WRX. One of the instructions is to split the hood into two pieces.

I have created this surface from cv curves and need to split it at an isoparm. I've tried several things but they all fail.

How can I split or boolean this surface into two different surfaces???

I've tried the boolean command but I get an error using a nurbs plane as my slicing tool.
svenip
05-30-2002, 10:16 PM
right click on the surface and select isoparm. then select one of the isoparms or drag one into the position where you wanna split. then edit surfaces-detach surfaces.
studiomiguel
05-31-2002, 03:10 AM
Sven to the rescue again...

I'm out of the saddle until Monday, but rest assured I'll be giving this a shot.

Thanks,
Michael
CGTalk Moderation
01-13-2006, 06:00 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.