PDA

View Full Version : Techniques for Modeling Knots?


polyvin
10-16-2010, 04:21 PM
One of the most time consuming and annoying things I've come across while modeling is creating knots, or at least the illusion of knots. The only i knew how to create them where to either create Spline IK rigs, or extrude along curves depending on the rope, but creating a spline ik rig takes a good amount of time and extruding along curves usually requires some clean up. Just wondering if you guys had any work-flow tips or tools that make creating knots easier.

CGTalk Moderation
10-16-2010, 04:21 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.