PDA

View Full Version : Apache AH64D work in progress


Glynn-Richards
08-26-2010, 11:34 AM
Hi there, well i have to say this is my first attempt at modeling a helicopter, this one particular is the american Apache AH64d, I know there is quite alot more work that needs doing however this is what I have so far. I would be very greatfull for opinions and constrructive critisism as it always helps grately :) cheers http://a.imagehost.org/0308/Apache_ah-64d.jpg

Kanga
08-26-2010, 12:33 PM
Hi Glynn.
Lookin good.
Not easy to see but it looks like you may have some tris going on in the geometry. Can you show a smoothed version with the wireframe on in iso mode, so we can see the main edges only?

Glynn-Richards
08-26-2010, 04:00 PM
Hey thanks kanga.
Well I though that picture was a bit daft as there wasnt too much to see. So Iam just putting these screen grabs up too. should give you a better view of the topology :) sorry I dont quiet know what you mean by the "view in iso mode" but iam intrested to know, however here is a smoothed screen grab too.
http://a.imagehost.org/0790/smooth.jpg

Glynn-Richards
08-26-2010, 04:07 PM
And this one. I cant say Iam very keen on the back tail tho , were it meets the tail fin....bit untidy :/http://i.imagehost.org/0652/smooth_back_wire.jpg

CGTalk Moderation
08-26-2010, 04:07 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.