PDA

View Full Version : birth texture prob.


luxeomni
07-26-2010, 05:15 PM
Hi, i m doing the a disolve effect, based on a gradient ramp animated texture, and i m triggering the particles by a birth texture, everything worked fine till i decided to rearanged some stuff in my particle flow panel. Now heres the problem : my particles are still following the "patern of the texture" but not the mesh attached to it, they stay in place, i then decided to aplly again the mesh to the birth texture controller but when i psush the "initialization parameters" button it opens the parameters of one of my drag force !...can't acces the parameters of the birth texture anymore.

Anyone can help ?

Regards
G.

CGTalk Moderation
07-26-2010, 05:15 PM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.