PDA

View Full Version : Clusters Gone

stjons
02-16-2010, 12:09 PM
I'm very confused right now, all my control clusters have gone from myt scene, and if I select my curve and go to edit curve>selection> Cluster Curve I get an error that says Cannot convert data of type int[] to type int.

I can only assume I have done something wrong somewhere, everything was working fine, then I created some blendshapes for my character, set them all up and realised the trunk of my character wasn't moving with the control handles anymore. After looking through my outliner I noticed where my clusters had once been there was now groups of the same name.

Has anybody run into this before?

Cheers
Jonny
Darksuit
02-16-2010, 09:21 PM
not sure what you did prior to this. However if you do not see the cluster in the outliner or if you select the curve in the hypergraph and show the inputs/outputs and you don't see a conneciton to the culsters they may have gotten deleted at some point inadvertly.
MacF
02-19-2010, 05:10 AM
did you accidentally duplicate any nodes during your blendshape setup?

having groups of the same name there kinda sounds like an accidental duplicate where you've lost all your input connections to those cluster controls.

don't know if this problem is recoverable, mate
CGTalk Moderation
02-19-2010, 05:10 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.