PDA

View Full Version : Trouble with NURBS

kyleragaller
01-06-2010, 04:48 PM
Im working in Maya2010.

When I click on my nurbs surface to edit the cv points, all of the cv's fade from orange to red. They are no longer purple and if i try and move a point, the whole geo moves. What is going on and can i get my surface back to where the cv points are purple again?

I did some converting from nurbs to subdivs and back again. Could this be the problem?

Lemme know what you guys think.

Kyle.
Dare-o
01-07-2010, 01:25 PM
i believe you have the soft selection enabled on your move tool. If you press the hotkey 'b' it should disable the soft selection.
whj714
01-08-2010, 07:52 AM
Im working in Maya2010.

When I click on my nurbs surface to edit the cv points, all of the cv's fade from orange to red. They are no longer purple and if i try and move a point, the whole geo moves. What is going on and can i get my surface back to where the cv points are purple again?

I did some converting from nurbs to subdivs and back again. Could this be the problem?

Lemme know what you guys think.

Kyle.


I have also experienced the same problem
CGTalk Moderation
01-08-2010, 07:52 AM
This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.