CGTalk - attach surface problem

View Full Version : attach surface problem

parel

05-12-2002, 10:55 PM

I am making a patch model for a face. I tried to attach these two surfaces to form a continous blended surface. The surfaces are not attaching at the right isoparm edge. Whats going on?

parel

05-12-2002, 10:59 PM

the botttom isoparm of the patch on top gets attached to the bottom isoparm of the patch below, instead of the topmost isoparm

parel

05-12-2002, 11:01 PM

Does anyone have any tips in general about patch heads and modeling them?

Jhonus

05-12-2002, 11:38 PM

try selecting the isoparms in component mode then use attach surfaces.

parel

05-12-2002, 11:58 PM

Thanks:love:

Why do you think that the surfaces blended the way that they did? Is there a setting that I could have changed?

svenip

05-13-2002, 07:29 AM

yes there are settings for the attach surfaces. after the attach you can find them either in the channelbox or the attribute editor. there are several attributes. REVERSE, SWAP and TWIST

CGTalk Moderation

01-13-2006, 06:00 AM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.