CGTalk - Nurbs attach Q

Kabab

07-30-2003, 12:10 PM

I modelling a car and i have these two surfaces which i want to attach so it becomes 1 perfect smooth surface with no seam but i want to maintain the sharp corner.

http://members.optusnet.com.au/bsanayei/ferrari/attach.jpg

Whats the method for this ?

If attach is not the way how can i make sure i have no seams between to adjacent nurbs patches.

Thanks :beer:

plotz

07-30-2003, 02:17 PM

If you want to keep the hard edge, then there really isn't a reason to do an attach.

Just adjust your tesselation settings on the surfaces that meet each other.

Usually you can just go into Tesselation "Options" for the surfaces in question and turn on "Smooth Edge".

If that doesn't work you can adjust the curve toelerance to higher quality.

If you decide that an attach is the way you want to go, then it should leave the edge if you check the option non to remove multiple knots, and don't use the blend option.

Elliotjnewman

07-30-2003, 02:21 PM

if you still would like to go and attach those two surfaces than you can do a fillet or attach sufraces. and to keep the hard edges just add some more isoparms in.

Ell.

misterdi

07-31-2003, 03:10 AM

Isn't attach surface with connect and keep multiple knots give you the result that you want?

:rolleyes:

CGTalk Moderation

01-15-2006, 06:00 PM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.