CGTalk - Mirroring then connecting

View Full Version : Mirroring then connecting

shockeddesign

07-24-2003, 12:48 AM

I have a problem, now i'm at work so I can't show you a working example of this dilemma. Ok when I mirror one side of an object say a head. For some reason I can't figure out why when I connect the two together as one, theres a tad bit of a crack in the middle of the head. Its like it knows I tried to connect the two. I weld each set of points to its side, is that wrong?

anyways its not a big deal but if I could get some advice that would be helpful. thanks

-Joe

discode

07-24-2003, 12:57 AM

You might want to open your statistics panel and delete all of the 1 or 2 point polys. Just a thought.:)

Rabid pitbull

07-24-2003, 01:29 AM

make sure before you mirror that all the center points are at 0 on the x axis. Also make sure that your mirror on 0 x.

CGTalk Moderation

01-15-2006, 05:00 PM

This thread has been automatically closed as it remained inactive for 12 months. If you wish to continue the discussion, please create a new thread in the appropriate forum.