adrianfava
06-02-2009, 02:49 AM
Hello ppl from cg :D this time I have a little question regarding the features of rhino. This the example, letīs say I've done a cube and the I fillet its edges and then I subtract a sphere from it, then I fillet edges again, and finally I modify the surface with one modifier, I donīt know either of them.
Is there any command, list or anything, which is possible to go back to one of those modifiers, or to erase one of them, letīs say I didn't liked the final result of the 1st fillet, so I want to change the radius, or I want it to deleted all...
I know that in 3dsmax you can do this just going to modifier panel, but I donīt know if this possibility is able on rhino, cause is isnīt how do you work on possible changes if you're to far from ctrl z...
Thanks :D really appreciate any response
Is there any command, list or anything, which is possible to go back to one of those modifiers, or to erase one of them, letīs say I didn't liked the final result of the 1st fillet, so I want to change the radius, or I want it to deleted all...
I know that in 3dsmax you can do this just going to modifier panel, but I donīt know if this possibility is able on rhino, cause is isnīt how do you work on possible changes if you're to far from ctrl z...
Thanks :D really appreciate any response